Brake Pads Back Plates Gluing Painting Room is assembled from several units including painting room, painting system, spray gun transmission device, tray transmission system, exhaust gas treatment system, etc.
- Configuration and Technical Parameters:
- Painting room size: 1900×2860×2130mm
- Chain center distance: 650mm
- Operating height: 800±50mm
- Painting System:
- Spray gun: Japan Iwata spray gun WA200-1.2 caliber
- Working pressure: 0.29～3 MP
- Paint spray volume: 500ml/min
- Spray width: 400mm
- Double diaphragm pump: Flow rate: 5.0L/min (0.4kg/cm2)
- Maximum suctionheight: 7m
- Pipeline: equipped with standard piping, STNC high frequency solenoid valve, etc.
- Spray Gun Transmission System:
- Composed of servo motor, spray gun holder, linear guide rail and timing belt
- Linear slide: rod diameter 20CA, stroke 810mm
- Drive motor: Servo motor (through linear guide and timing belt to drive the movement of the spray gun)
- Motor power: single-phase 220V 120W (speed adjustable)
- Tray Transmission System
- Power supply: 3N+PE 380V 50Hz
- Traction power: 0.75W (adjustable speed)
- Traction mode: frequency conversion deceleration motor drives the conveyor chain to convey
- Conveyor chain: adopt conveyor chain with side bending plate to convey
- Conveying speed: 0.5～8m/min adjustable (adopt frequency conversion speed regulation)
- Exhaust gas treatment system
- The waste gas treatment system adopts 2 adsorption systems, the firstis honeycomb adsorption cotton and the second is activated carbon adsorption. The dual waste gas treatment system has more thorough and clean waste gas treatment.
Reviews
There are no reviews yet.