No products were found matching your selection.
Other Related Products
-

Automatic Brake Pad Press Machine Group Set with Weighting System is a combination of a weighing system, 1 to 6 units of hot pressers, automatic manipulators on travelling rack, and other accessories. It is mainly responsible for the following 6 procedures during the whole production process: One-layer or double-layer friction mixes weighing Mixes flattening(pre-pressingif with…
-

Brake Pads Backing Plates Ultrasonic Clean Machine is used for steel backing plate surface degreasing with ultrasonic before gluing. Specification: – Size:L8565*W2120*H1290mm – Load and Lay Off Material Platform (Length/Width):Each With 500×440mm – Cleaning Tank Inner Size:L2300×W440×H200mm – Spray Rinse Inner Size:L800×W440×H150mm – Compressed Air Cutting Water Inner Size:L600×W440×H150mm – Hot Oven Inner Size:L2998×W440×H150mm – Conveyor Belt Width:400mm – Liquid Storage Tank:L700*2…
-

Automatic Brake Lining Hole Drilling Machine is used for drilling rivets holes of CV brake lining automatic.It realizes automatic feeding, automatic clamping, automatic indexing, automatic rotation, automatic drilling, automatic cutting, and automatic stacking. One worker can operate 3 to 4 machines. Technical Parameters: Click To See More Brake Lining Machines
-

Car Brake Pads Friction Materials Mix Machine applied the advanced technology of three-dimensional circulating mixing principle, are designed to mix friction materials automatically. It adopts new high-speed mixing blades and scientific mixing barrel, pneumatic feeding, to ensure that no dead angle in the chamber. It is equipped with cold water circulating cooling system, adapting to…
-

-

PRODUCTION DESCRIPTION: Brake Pads Friction Material-Fiber Steel Wool is a friction raw material filler, can be used in all kinds of friction materials. It can provide the friction products excellent stable performance over a wide temperature range, with low wear rate and good heat dissipation. Chopped steel fiber is made from high quality low carbon…
-

Brake Pads Friction Material- Wollastonite is a widely used friction material reinforced fiber, which is gradually replace asbestos as a main reinforced fiber during the friction material production, such as Brake Linings, brake pads, and other brake system friction material. GRANULARITY(SIEVE ANALYSIS,PARTICLE SIZE) Length of Fiber (lf): 0.384mm Diameter of Fiber (df): 20μm Length to Diameter Ratio…
-

Car Brake Pads Compressed Air Machine is an equipment that supply the compressed air power for some machines and equipments for brake pads production. Technical Parameters: – Screw Group:4,5 Tooth Rotor – Compressing Format: Continuous,Single Stepped – Compressed Air Outlet Pressure:P2=0.8MPa – Cooling Mode:Air Cooling – Heating Platen Area: 550mmX450mm – Compressed Air Outlet Temperature:10℃~15℃ Higher Than The Environment Temperature – Lubricating Oil…
-

Brake Pads Back Plates Assembling Automatic Production Line is an full automatic production line for brake pads back plates with a complete production process. Technical Parameters: Punch Machine: 1100KN/1250KN/1600KN Main Robot Machine: Feeding Materials Punch Machine: Holes Punch Punch Machine: Pins Punch Punch Machine: Side Punch Hydraulic Press Machine:3250KN; Fine Blanking Robot Hands: Moving/Reversal Deburring Machine:Removing…