CV Brake Pad Press Machine Group Set with Weighting System is a combination of a weighing system, 1 to 6 units of hot pressers, automatic manipulators on travelling rack, and other accessories. It is mainly responsible for the following 6 procedures during the whole production process: One-layer or double-layer friction mixes weighing Mixes flattening(pre-pressingif with…
Brake Pads Friction Materials-Nitrile Butadiene Rubber(NBR) also known as Butadiene Acrylonitrile rubber, is a widely used friction material adhesive, with good cold resistance, abrasion resistance, oil resistance, and elasticity. Rubber powder works not only as the binder, but also as an inorganic filler in the friction materials. It can be evenly mixed with resin to…
Car Brake Pads Sand Blasting Machine is used for cleaning the out surface of a finished brake pad by silicon sands to present a clean and smooth appearance before powder coating, which is equipped with an Air Compressor to blow out silicon sands. Technical Parameters： – Working Room Size: Width ≤500mm – Application Range: Metal or…
Car Brake Pad Back Plates Production Machine is a production machine for car Brake Pads Back Plates, with automatic feeding and moving robots. Technical Specifications: Sliding Block Pressure: 800KN Sliding Block Stroke:160mm Stoke Numbers:60 times/min (fixed);40-60 times/min (alterable) Die Height:320mm Die Height Adjustment:80mm Dimension From Slider Centreline to Machine:310mm Slider Base Size:540mm (L/R)*460mm(F/B) Shank Hole…
Brake Pads Automatic Material Weighting and Mixing System is used for weighing raw materials automatic before mixing.This system operates fully automatic base on the friction material formulation which is saved in PLC. If operator selects saved formulation, automatically weighing and collecting different weighed material and then discharge to the linked Mixer. Feature: -The whole process…
Car Brake Pads Compressed Air Machine is an equipment that supply the compressed air power for some machines and equipments for brake pads production. Technical Parameters: – Screw Group:4,5 Tooth Rotor – Compressing Format: Continuous,Single Stepped – Compressed Air Outlet Pressure:P2=0.8MPa – Cooling Mode:Air Cooling – Heating Platen Area: 550mmX450mm – Compressed Air Outlet Temperature:10℃～15℃ Higher Than The Environment Temperature – Lubricating Oil…
Brake Pads Cleanning Machine Before Powder Coating is used to clean the back plate side of brake pads before powder coating, to guarantee a smooth coating performance. Technical Parameters Production Capacity: About 3000 pcs/hour Speed: 9 meters/minute Brush: 3 Pcs Brush Motor: 1.1kw*3 Transport Motor: 0.75kw Dust Collect: Seperately for single brush
Car Brake Pads Electrostatic Powder Coating Line applies Infrared Heating Technology, which is 30-50% energy saving compared to electric heating technology with same electric power, the ordinary electric heating tunnel applies heat conduction to transfer the heat energy to brake pads, however, the infrared heating tunnel applies thermal radiation by special short and medium infrared…
Brake Pads Backing Plates Gluing Machine adopts glue spraying room, conveyor, touch screen control, pneumatic system. The steel backing plates are put on the customized spray adhesive tablets by workers, automatically sent to spray adhesive by conveyor, automatically put in the spray adhesive and then into the connected oven to dry and cool. Spray Adhesive…