Car Brake Pads Electrostatic Powder Coating Line applies Infrared Heating Technology, which is 30-50% energy saving compared to electric heating technology with same electric power, the ordinary electric heating tunnel applies heat conduction to transfer the heat energy to brake pads, however, the infrared heating tunnel applies thermal radiation by special short and medium infrared…
Brake Pads Equal Pressure Hot Press Machines are the most advanced type press machines used for making OE qualified high end passenger car brake pads, with its high production efficiency, and good production quality. The machine adopts advanced floating cylinder design to ensure that each brake pad in the same mold is subject to the…
Car Brake Pads Roller Gluing Machine for brake pad back plates, which includes three parts in this machine, which is widely used in brake pad factory, with a higher production efficiency, and good gluing performance. Technical Parameters： – ROLLER GLOWING MACHINE – ADHESIVE PART : HEATING / DRYING TUNNEL : COOLING TUNNEL : Click To…
Car Brake Shoe Lining Out Arc Grinding Machine is used for grinding the out arc surface of car Brake Shoes. The complete working station is protective covered. With door open and close protective device. Grinding Process: -Open the door -Put the linings on the mold -Close the door -Start the machine -Finish the grinding. -Take…
Car Brake Shoes Automatic Packing Line is used for packing finished Brake Pads, Brake Linings and all the finished or semi-finished products by film shrinking autonomic. Technical Parameters： – Voltage: 380V,50Hz,16A,3.5KW – Pressure: 5-7KG/CM2 – Pacing Speed: 0-20 bags/min – Machine Size (mm): L x W x H = 1670 × 766 × 1515 mm – Table Height: 780mm – Object Maximum Size: 500 × 400 × 150mm, W + H ≤ 470mm, H ≤ 150mm – Deliver Speed: 20m/min – Sealing…
CV Brake Pads Brake-In Strips Gluing Machine is designed to coat the brake-in strips on the friction surface. Coating different pattern of the glue strips shall change the pattern molds on this machine. Technical Parameters： Size of the machine(L x W x H): 650mm x 800mm x 1600mm Working Table Size(L x W): 280mm x…
Motorcycle Finished Brake Shoe Tunnel Type Oven is used to combined the brake shoe and friction linings by heating in the hot oven, Technical Parameters： Total Power: 90 KW Machine Size: 21000mm*1150mm*1300mm Heating Pipe: Stainless Heating Pipe Transfer Type: Mesh Conveyor Wind Motor: 0.37KW*5 Temperature: Automatic PLC Control Production Capacity: 3000 sets/8 hours Click To…
Motorcycle Brake Pads Compressed Air Machine is an equipment that supply the compressed air power for some machines and equipments for brake pads production. Technical Parameters: – Screw Group:4,5 Tooth Rotor – Compressing Format: Continuous,Single Stepped – Compressed Air Outlet Pressure:P2=0.8MPa – Cooling Mode:Air Cooling – Heating Platen Area: 550mmX450mm – Compressed Air Outlet Temperature:10℃～15℃ Higher Than The Environment Temperature – Lubricating Oil Quantity:About…
Car Brake Pads Combined Grinding Machine combines procedures of slotting, coarse grinding, fine grinding, and dust cleaning at one machine with high efficiency. Technical Parameters： Grinding Unit Spec. Rough Surface Grinding Unit: 1 Set (Vertical spindle 11.25 Kw) Slot Grinding Unit: 1 Set (Horizontal spindle 7.5 Kw) Fine Surface Grinding Unit: 1 Set (Vertical spindle…